Pocket Dragon

A dragon small enough to live in a school bag.

$24.00

Colour

Dragon Red

Printed to order, dispatched in 2–4 days
Plant-based PLA, sanded by hand

NZ$1 from this order goes to UNICEF Aotearoa through the IdeaPrints Give Back promise. IdeaPrints Give Back promise

About this toy

I drew this one in the back of my maths book, and the whole point was a dragon that looked friendly instead of scary. That's why the wings tuck in close to the body rather than spreading out — nothing sticks out to snap off in a pocket. I print each dragon lying on its side so the horns and the ridge down its back come out sharp, which takes about nine hours.

What's in the box

One 3D-printed toy, hand-finished and checked by me
A card with the original pencil sketch it came from
Recycled paper wrapping — no plastic in the packaging
A short note about the NZ$1 going to UNICEF

Specifications

Material: PLA — a plant-based, non-toxic plastic
Approx. size: 11 cm
Print time: 7 h
Recommended age: 3 years and up

Every toy is printed one at a time, so sizes are approximate and no two come out exactly the same.

Looking after it

Wipe it with a damp cloth. No dishwasher, please.
Keep it out of hot cars and off sunny windowsills — PLA goes soft in real heat.
It's a toy, not a chew toy: not for children under 3, and not for pets.
If something snaps, email me a photo. I printed it, so I can print you another one.